Jeep SYE and Driveshafts
This kit is a MUST if you installed a 2” or taller suspension lift in your 1987- 2006 Wrangler (not needed for body lifted Jeeps). The kit fits all 1987 and up NP 231 transfer cases. A Slip Yoke Eliminator Kit (SYE) will eliminate the need to drop your transfer case in order to avoid drive train vibrations that are caused by taller suspension lift. The purpose of this kit is to replace the slip yoke portion of the NP 231 with a fixed yoke and CV-style drive shaft assembly. The Mega Short SYE (18676.72) is designed to be used in the same lift applications as the other standard SYE kit (2” and up). The main advantage to the new Mega Short SYE is that it allows for a much longer drive shaft to be used (additional 3”). This reduces drive shaft angle, improves bearing & U-joint life, reduces driveline vibrations. It also has a shorter and stronger main shaft design with improved oiling. Will not work with cable driven speedometers. Not for use with Rubicon models.
87-93 Wrangler with up to 3” Lift, Rear |
|
87-93 Wrangler with over 3” Lift, Rear |
|
94-95 Wrangler with up to 3” Lift, Rear * |
|
94-95 Wrangler with over 3” Lift, Rear * |
|
97-06 Wrangler with 2”-6” Lift, Rear |
|
97-06 Wrangler with 3.5”-6” Lift, Rear (for Mega Short SYE only) |
|
07-10 Wrangler 2 Door or 4 Door, Front |
|
07-10 Wrangler 2 Door, Rear |
|
07-10 Wrangler 4 Door, Rear |
|
87-06 Wrangler Slip Yoke Eliminator Kit (with NP231 transfer case) * |
|
87-06 Wrangler Mega Short Slip Yoke Eliminator Kit with Vehicle Speed Sensor
(with NP231 transfer case) * |
|
87-06 Wrangler Mega Short Slip Yoke Eliminator Kit without Vehicle Speed
Sensor (with NP231 transfer case) * |
|
Speed Sensor for Mega Short Slip Yoke Eliminator Kit #18676.70 |
|
Replacement Bearing for Mega Short Slip Yoke Eliminator Kit #18676.70 |
|
*NOTE: A CV equipped drive shaft will be required for this conversion kit.
**These drive shafts use 3-5/8" wide U-joints, please verify the U-joint size.
